Toyota 22R-E - If Rear Oil Seal Retainer Is Removed from Cylinder Block (Replacement of Rear Oil Seal); If Rear Oil Seal Retainer Is Installed on Cylinder Block (Replacement of Rear Oil Seal)

4. IF REAR OIL SEAL RETAINER IS INSTALLED ON
CYLINDER BLOCK (Replacement of rear oil seal)
(a) Using a knife, cut off lip of oil seal.
(b) Using a screwdriver, pry out the oil seal.
NOTICE: Be careful not to damage the crankshaft. Tape
the screwdriver tip.
(c) Apply MP grease to a new oil seal lip.
(d) Using SST and a hammer, tap in the oil seal until its
surface is flush with the timing chain cover edge.
SST 09223 – 50010
(c) Apply MP grease to a new oil seal lip.
(d) Using SST and a hammer, tap in the oil seal until its
surface is flush with the rear oil seal retainer edge.
SST 09223–41020
3. IF REAR OIL SEAL RETAINER IS REMOVED FROM
CYLINDER BLOCK (Replacement of rear oil seal)
(a) Using a screwdriver, remove the oil seal.
(b) Apply MP grease to a new oil seal lip.
(c) Using SST, install the oil seal.
SST 09223–41020
–ENGINE ENGINE MECHANICAL
EG1–65