Toyota 22R-E - Connect Transfer Shift Linkage (4 WD A;T); Install Shift Lever (M;T); Install Compressor to Bracket (with A;C); Install Ps Pump with Ps Pump Bracket (W;Ps)

20. (M/T)
INSTALL SHIFT LEVER
(a) Apply MP grease to the shift lever.
(b) Instal) the shift lever to the transmission.
21. CONNECT GROUND STRAPS TO ENGINE REAR
SIDE AND RH SIDE
22. (with A/C)
INSTALL COMPRESSOR TO BRACKET
(a) Install the compressor with the four bolts.
(b) Install the drive belt and adjust the belt tension.
23. CONNECT GROUND STRAP FOR PS PUMP BRA–
CKET
24. (w/PS)
INSTALL PS PUMP WITH PS PUMP BRACKET
Install the PS pump with the four bolts.
25. CONNECT FOLLOWING CABLES:
(a) (A/T)
Throttle cable
(c) Connect the No.1 and No.2 transfer shift linkage to
the cross shaft.
17. (A/T)
CONNECT MANUAL SHIFT LINKAGE TO PNP
SWITCH
18. INSTALL PROPELLER SHAFT
(See PR section)
19. (R150)
INSTALL SHIFT LEVER RETAINER
16. (4WD A/T)
CONNECT TRANSFER SHIFT LINKAGE
(a) Apply MP grease to the cross shaft joint.
(b) Install the cross shaft to the body.
–ENGINE ENGINE MECHANICAL
EG1–73