INSPECT VOLTAGE OF ECM
Check the voltage between each terminal of the
wiring connectors.
• Turn the ignition switch ON.
• Measure the voltage at each terminal.
HINT:
• Perform all voltage measurements with the con–
nectors connected.
• Verify that the battery voltage is 11 V or more
when the ignition switch is ON.
ENGINE CONTROL MODULE (ECM)
ECM INSPECTION
HINT: The MFI circuit can be checked by measuring
the voltage and resistance at the wiring connectors of
the ECM.
–ENGINE MFI SYSTEM
EG1–215
To Next Page
Loading...
