CYLINDER BLOCK ASSEMBLY
(See Components)
HINT:
• Thoroughly clean all parts to be assembled.
• Before installing the parts, apply new engine oil
to all sliding and rotating surfaces.
• Replace all gaskets, 0–rings and oil seals with
new parts.
1. INSTALL MAIN BEARINGS
HINT:
• Main bearings come in widths of 20 mm (0.79 in.)
and 22 mm (0.87 in.). Install the 22 mm (0.87 in.)
bearings in the No.1 cylinder block journal posi–
tion with the main bearing caps. Install the 20
mm (0.79 in.) bearings in the other positions.
• Upper bearings have an oil holes lower bearings
do not.
3. INSTALL BEARINGS
(a) Align the bearing claw with the groove of the con–
necting rod or connecting cap.
(b) Install the bearings in the connecting rod and conne–
cting rod cap.
2. INSTALL UPPER THRUST WASHERS
Install the thrust washers under the No.2 journal po–
sition of the cylinder block with the oil grooves facing
outward.
3. PLACE CRANKSHAFT ON CYLINDER BLOCK
(a) Align the bearing claw with the claw groove of the
main bearing cap or cylinder block.
(b) Install the bearings in the cylinder block and main
bearing cap.
–ENGINE ENGINE MECHANICAL
EG2–117
To Next Page
Loading...
