(l) (C & C only)
Disconnect the two water by–pass hoses from the
EGR valve.
(m) Remove the five nuts, EGR valve with the pipes and
two gaskets.
(h) Disconnect the vacuum hose from the gas filter.
(i) (California and C & C)
Disconnect the EGR gas temp. sensor connector.
(j) Disconnect the EGR vacuum hoses from the air pipe
and EGR vacuum modulator.
(f) Disconnect the cold start injector connector.
(g) Remove the union bolt, two gaskets and cold start
injector tube.
(e) Disconnect the No.5 water by–pass hose from the
water by–pass pipe.
(k) Remove the nut, two bolts, intake chamber stay and
throttle cable bracket.
–ENGINE MFI SYSTEM
EG2–214
To Next Page
Loading...
