(a) Disconnect the No.1 fuel hose from the fuel tube.
(b) Connect SST (hose and union) to the fuel tube.
SST 09268–41045 (09268–52010)
(c) Remove the fuel pressure regulator.
(d) Connect SST (hose) to the fuel pressure regulator with
SST (union).
SST 09268–41045 (09268–52010)
(e) Install SST (union) to the injector and hold the injector
and union with SST (clamp).
SST 09268–41045
(f) Put the injector into the graduated cylinder.
HINT: Install a suitable vinyl tube onto the injector to
prevent gasoline from splashing out.
(i) Using SST, connect terminals FP and +B of the
DLC1.
SST 09843–18020
HINT: Fuel pump will operate.
(g) Connect the battery negative cable.
(h) Turn the ignition switch ON.
HINT: Do not start the engine.
2. TEST INJECTION OF INJECTOR
CAUTION: Keep injectors clear of sparks during the test.
–ENGINE MFI SYSTEM
EG2–225
To Next Page
Loading...
