Xerox Phaser 790

10. Installing user software in a Windows 2000 environment
Xerox Phaser 790
10–21
29. Select either the Spool print jobs so program finishes printing
faster option or the Print directly to the printer option. The
selection you make depends on the action you took in step 3:
• If you set the Port Timeout in Seconds to 10, you can select
either option; however, spooling is faster.
• If you set the Port Timeout in Seconds to 5, select the Print
directly to the printer option.
30. To confirm the connection, print a test page. Select the General
tab in the Properties dialog box. Select the Print Test Page
button.
31. Perform one of the following:
• Select OK if the job printed normally.
• Select the Troubleshoot button if the page did not print or did
not print correctly. Follow the Troubleshooting wizard to
diagnose and solve the problem.
32. Select Close to exit the Printer Properties dialog box.
Configure any options installed on your printer. Refer to the section
Setting the printer options.
After setup is complete, you are ready to print your jobs.