Xerox Phaser 790

21. Performing the setup from WebSetup
Xerox Phaser 790
21–15
6. If you have an AppleTalk network, select the Protocol2 tab from
the Network Setup tabs. In this tab, you can specify the AppleTalk
protocols used to send jobs to the printer.
a. In the AppleTalk box, select the Enable AppleTalk check
box.
b. From the Select Zone drop down box, select the AppleTalk
zone in which you want the printer to display. If there is only
one zone, the printer is assigned to that zone automatically.
If you cannot find an AppleTalk zone, your network may
have no defined zones or the network cable is not
connected.