Unpacking an SH4R and SH4R-2 Shelf
8. Move the shelf to a stable surface in the work area and place it on a static-dissipative
mat. Do not release your grip until the shelf is secure.
ELECTROSTATIC CAUTION
Risk of damage due to electrostatic discharge!
Keep the shelf in its ESD protective bag until you are ready to inspect it.
Do not drop the shelf or any modules on a hard surface - damage to
internal components may result. If any components are dropped,
return them to ADVA Optical Networking for examination and repair.
9. Remove the ESD protective bag from the shelf and lay it aside.
10. Verify that you have the proper shelf type, using the Product IDLabel for
identification.
11. Open the accessory kits and boxes that contain the cables, documentation, and
management software. Do not use a knife to open these boxes.
12. Visually check the shelf and accessories for external damage. If identified, make
note of any damaged or missing items.
13. Verify that you have all of the necessary equipment, cables, documentation, and so
forth by comparing the your shipment's packing slip to your purchase order copy.
Some shelves are ordered preconfigured according to specific
requirements. Differences between your site planning and the delivered
configuration may occur caused for example by last-minute changes.
14. If any items are missing or you need additional information, notify your customer
service representative or ADVA Optical Networking immediately.
Each shelf comes with two 19-inch rack-mounting brackets preinstalled
and each unoccupied shelf slot is filled with the appropriate slot cover.
15. Save the packaging material until the operational checkout of the HD equipment is
complete. Storing all the shipping boxes and packaging material enables the HD
components to be repacked for a possible transport to another installation site or to
be returned for a needed repair.
249 FSP 3000R7 High-Density Subshelf Guide - R17.2 - Issue:B
To Next Page
Loading...
