Allen-Bradley Kinetix 5100 2198-E1004-ERS - Edit Settings From the Display

Rockwell Automation Publication 2198-UM004A-EN-P - October 2019 101
Use the Keypad Interface Chapter 5
Edit Settings From the
Display
Access the Setting display from the Drive Status display by pressing the key.
When the drive is disabled/servo off, perform the following steps.
1. Press the key to enter the editing mode.
Use the keys to scroll through the Network setting, reset, and parameter
setting displays.
2. Press the key to return to the previous display.
Figure 68 - State Switch Machine of Information Display and Setup
Edit Network Settings
From the Setting display, perform the following steps.
1. Press the key to go to Network Setting display.
2. Press again to enter the Static IP display.
From that display, there are two choices:
• Press again to set a static IP address. See Set Static IP Address
.
• Press the key to turn DHCP on or off. See
Turn DCHP On or Off
on page 103.
Set Static IP Address
On the Static IP Address display, perform the following steps.
1. Press the key to enter the IP Setting display.
2. Press the key to enter the edit display.