Rockwell Automation Publication 2198-UM004A-EN-P - October 2019 161
Chapter 8
Configure the Drive in Studio 5000 Logix
Designer Application
Studio 5000 Logix Designer
Application
For help using the Studio 5000 Logix Designer® application as it applies to
configuring the ControlLogix® or CompactLogix™ controllers, see the Additional
Resources on page 7.
Version History
Each release of the Studio 5000 Logix Designer application makes possible the
configuration of additional Allen-Bradley motors, actuators, power supplies, and
drive features not available in previous versions.
Install the Kinetix 5100 Add-On Profile
Download Add-On profiles (AOP) from the Product Compatibility Download
Center (PCDC) website:
http://compatibility.rockwellautomation.com/Pages/home.aspx
.
Topic Page
Studio 5000 Logix Designer Application 161
Configure the Logix 5000 Controller 162
Configure the Kinetix 5100 Drive Modules 166
Download the Program 168
IMPORTANT To configure additional motors, actuators, and drive features with your
Kinetix® 5100 servo drive, you must have drive firmware 1.001 or later.
Refer to Table 64
to determine if you need to install the Kinetix 5100
Add-on Profile.
Table 64 - AOP Installation Requirement
Drive Firmware Version Logix Designer Application Version Kinetix 5100 AOP Needed
1.001 or later
30.00, 31.00, 32.00 Yes
33.00 or later No
To Next Page
Loading...
