104 Rockwell Automation Publication 2198-UM004A-EN-P - October 2019
Chapter 5 Use the Keypad Interface
Use the keys to change the value of the selected digit (flashing). Use the
key to move between digits.
6. Press the key to confirm the edit or the key to cancel the change
and to return to the Parameter display.
When you press the key, the drive saves the value and displays Saved or
another status message on the display. See Table 60 on page 104
.
Save Display
When you have set the parameter, press the key to save. The display shows
one of the following symbols for one second.
Table 60 - Parameter Status Display
Displayed Symbol Meaning Description
Saved Correctly saved the setting value.
Locked Entered the wrong password or no password has been inputted.
Out of Range Incorrect value or the input is reserved for this value.
Power On The parameter will be effective after the servo drive is re-powered.
To Next Page
Loading...
