Rockwell Automation Publication 2198-UM004A-EN-P - October 2019 417
Programming via Drive Parameters Chapter 15
Use the X position of the ID112 (P0.053) parameter to set the filter time. This
figure provides an example.
Description of System
Variable Monitoring
Each system variable has a code, and users can use ID668…ID672
(P0.017…P0.021) to set the code and monitor the system variable. Each system
variable is stored in the 32-bit format (long integer) of the drive.
There are two ways to monitor the system variables. You can monitor via the
panel display or you can monitor via the system variable monitoring parameters.
Panel Display
When the panel is in Real Time Data Display mode, press the UP / DOWN keys
to select the variable to be monitored. See Chapter 5
, Use the Keypad Interface.
YUZ
X
• X: First filter time
•Y…U: Reserved
Example of the first filter:
To Next Page
Loading...
