Rockwell Automation Publication 2198-UM004A-EN-P - October 2019 491
Use the Scope Function in KNX5100C Software Appendix E
Select Communication
Channels
The scope speed determines the available channels. After you choose the
communication speed, the system disables the unavailable channels automatically.
• CH (Channel) (1) - To display data on the screen, check the channel that
you want to view.
• 32 bit (2) - This option is used to select the data length of the channel.
– When the checkbox is checked, it indicates that it is a 32-bit data. At
this time, two 16-bit data (the data of CH1 and CH3) is combined into
a 32-bit data and CH3 is disabled. By the same logic, the data of CH2
and CH4 is combined into a 32-bit data channel and CH4 is disabled.
– When the checkbox is not checked, it indicates it is 16-bit data. You can
enable each channel.
• Color Selection (3) - You can choose the channel display color by
preference. When you click, a color selection dialog box appears and you
can choose your favorite color.
• Data (4) - If there is data on the screen, when you move your mouse over
the data, the current data value of the point where the mouse is located is
shown.
• Relative Value (Rel. val.) (5) - If there is data on the screen, when you move
your mouse over the data, the data value relative to the value of the starting
point is shown.
TIP Double click the Data field to display the data with BIT or HEX format.
To Next Page
Loading...
