Rockwell Automation Publication 2198-UM004A-EN-P - October 2019 103
Use the Keypad Interface Chapter 5
Turn DCHP On or Off
On the DHCP display, perform the following steps.
1. Press the key to enter the DHCP editing display.
2. Press the key to turn the switch OFF or ON.
3. Press the key to return to the DHCP editing display.
4. Press the key to return to the IP Setting display.
Edit Parameter Settings
From Settings display, perform the following steps.
1. Press the key to get to Network Settings.
2. Press the key for Parameters.
3. Press the key for the parameter editing mode.
Starting with group 0, Use the keys to move between parameter
numbers within the group.
4. Use the key to move to the next parameter group.
Use the keys to move between parameter numbers within a group.
5. Once you have navigated to the parameter you want to edit, press the
key to select it.
To Next Page
Loading...
