Rockwell Automation Publication 2198-UM004A-EN-P - October 2019 187
Tuning Chapter 9
Tuning Mode 2 in KNX5100C Software
You can use KNX5100C software for manual tuning in Mode 2 by choosing
Manual Tuning from the Function List and selecting Mode 2.
Figure 78 - Selecting Mode 2 Manual Tuning
The Smoothing and Filtering tab lets you configure the parameters related to the
Low Pass and Moving filters and S-curve, depending upon your configured
Operating mode. See Chapter 10
for details on filters and s-curves.
To Next Page
Loading...
