Rockwell Automation Publication 2198-UM004A-EN-P - October 2019 111
Set Up EtherNet/IP Communication Chapter 6
Set Network Parameters by
Using the KNX5100C
Software
1. Connect USB cable between your drive and workstation, and then apply
power to your drive
2. Open your KNX5100C software and click New Device.
3. To go online with the drive, click the OFFLINE button.
The KNX5100C software reads the parameters from your drive.
4. From the Function List, click Drive IP Address Setting.
The Drive IP Address Setting dialog box appears, and the current IP
Settings are displayed.
5. Choose between STATIC IP and DHCP.
The default setting is STATIC IP.
6. If STATIC IP, then configure the following parameters:
– IP address
–Gateway
–Subnet mask
7. Click Apply.
8. To have the IP Settings take effect, click Reset Module from the tool bar.
To Next Page
Loading...
