Rockwell Automation Publication 2198-UM004A-EN-P - October 2019 121
Configure the Drive with KNX5100C Software Chapter 7
Connect to the Drive
You can change the COM port associated with your device after it was initially
set.
To change the COM port, perform the following steps.
1. From the Function List, click Communication Setting.
2. Choose the COM port associated with your drive.
3. Click Connect to connect your drive.
The online process options dialog appears.
4. From the three options, choose the one that is best suited as your online
process, and then click OK.
TIP
You can choose the COM port from the pull-down menu, or click
to refresh the COM port.
To Next Page
Loading...
