138 Rockwell Automation Publication 2198-UM004A-EN-P - October 2019
Chapter 7 Configure the Drive with KNX5100C Software
Stop Operation
This button stops any operation in progress.
Compare Parameters
Press this button to compare current parameters with existing parameters.
1.
On your personal computer, navigate to your target saved *.par file.
2. Select the file and click Open.
A message appears that the comparison process has started.
Choose an Operation Mode
There are three methods to change the operation mode in the KNX5100C
software:
• From the Operation Mode Selection List
•From the Setting page
• Via the Parameter Editor
For detailed information on how the drive operates in each mode, see
Chapter 10
, Modes of Operation.
To Next Page
Loading...
