Rockwell Automation Publication 2198-UM004A-EN-P - October 2019 429
Troubleshoot the Kinetix 5100 Drive System Chapter 16
Fault Information in the KNX5100C Software
In the KNX5100C software, you can use Fault Information to identify any faults
of the servo drive.
To identify any faults, perform the following steps.
1. In the Function List of the KNX5100C software, click Fault Information.
On the Fault Information tab, the most current fault is shown with detailed
information, including possible causes and subsequent corrective actions.
2. Click either available button for the following reasons:
• Click Show Faults to refresh the current fault information.
• Click Fault Reset to reset fault and remove the current list of fault
information if fault is cleared.
To Next Page
Loading...
