Rockwell Automation Publication 2198-UM004A-EN-P - October 2019 139
Configure the Drive with KNX5100C Software Chapter 7
From the Operation Mode Selection List
To select an operation mode setting, perform the following steps.
1. Use the pull-down menu to select an operating mode setting.
When you choose a new operation mode setting, the following message
appears.
From the Setting Page
To change the operation mode setting, perform the following steps.
1. From the Function List, select Start > Kinetix 5100 > Settings.
TIP If you click Yes, a power cycle is triggered.
If you click No, you are returned to the Settings view without a power
cycle. However, a reminder appears until you initiate a power cycle.
IMPORTANT Parameter ID117 (P1.001), ControlMode, is valid only after power cycle.
To Next Page
Loading...
