140 Rockwell Automation Publication 2198-UM004A-EN-P - October 2019
Chapter 7 Configure the Drive with KNX5100C Software
2. On the Operation Mode pull-down menu, select an operation mode.
3. Click .
When you choose a new operation mode setting, the following message
appears.
Via the Parameter Editor
To change the control mode in the Parameter Editor, perform the following steps.
1. From Function List, select Start > Kinetix 5100 > Setting > Parameter
Editor.
2. There are two ways to change parameter ID117 (P1.001) ControlMode:
• Change the ControlMode value by clicking directly in its value field
and typing a new value.
TIP If you click Yes, a power cycle is triggered.
If you click No, the original operation mode value is restored.
To Next Page
Loading...
