D-Link xStack DGS-3120 Series User Manual

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
1004
DGS-3120-24TC:admin#show stack_device
Command: show stack_device
Box ID Box Type H/W Version Serial Number
------ ---------------- ----------- --------------------
1 DGS-3120-24TC B1 PVT93CB000001
DGS-3120-24TC:admin#
103-5 config stacking_mode
Description
This command is used to configure the state of stacking function. By default stacking mode is
enabled. Administrators need to specifically configure the stacking mode to make the Switch
stackable. Stacking mode can be changed under standalone mode only.
Format
config stacking_mode [disable | enable]
Parameters
stacking_mode - Enable or disable the Switch’s stacking capability.
enable - Specify that the Switch's stacking capabilty will be enabled.
disable - Specify that the Switch's stacking capabilty will be disabled.
Restrictions
Only Administrator-level users can issue this command.
Example
To enable stacking mode:
DGS-3120-24TC:admin# config stacking_mode enable
Command: config stacking_mode enable
Change Box stacking_mode may cause devices work restart, still continue?(y/n)
y
Please wait, the switch is rebooting...
103-6 show stacking_mode
Description
This command is used to display the current stacking mode.
Format
show stacking_mode

D-Link xStack DGS-3120 Series Specifications

General

MAC Address Table	16K entries
Ports	10/100/1000BASE-T ports
VLANs	4094
Jumbo Frame	Up to 9KB
Power Supply	Internal power supply (depending on model)
Power over Ethernet (PoE)	No
Layer 3 Features	RIP
Quality of Service (QoS)	8 queues per port, DiffServ
Security Features	ACLs
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
SFP Ports	Combo 10/100/1000BASE-T/SFP ports and/or dedicated SFP/SFP+ ports (depending on model)