D-Link xStack DGS-3120 Series User Manual

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
1006
DGS-3120-24TC:admin# config stacking force_master_role state enable
Command: config stacking force_master_role state enable
Success.
DGS-3120-24TC:admin#
103-8 config stacking trap state
Description
This command is used to configure trap state for stacking.
Format
config stacking trap state [enable | disable]
Parameters
enable - Enable the Switch’s stacking trap.
disable - Disable the Switch’s stacking trap.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To enable the stacking trap state:
DGS-3120-24TC:admin#config stacking trap state enable
Command: config stacking trap state enable
Success.
DGS-3120-24TC:admin#
103-9 config stacking log state
Description
This command is used to configure log state for stacking.
Format
config stacking log state [enable | disable]
Parameters
enable - Enable the Switch’s stacking log.
disable - Disable the Switch’s stacking log.

D-Link xStack DGS-3120 Series Specifications

General

MAC Address Table	16K entries
Ports	10/100/1000BASE-T ports
VLANs	4094
Jumbo Frame	Up to 9KB
Power Supply	Internal power supply (depending on model)
Power over Ethernet (PoE)	No
Layer 3 Features	RIP
Quality of Service (QoS)	8 queues per port, DiffServ
Security Features	ACLs
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
SFP Ports	Combo 10/100/1000BASE-T/SFP ports and/or dedicated SFP/SFP+ ports (depending on model)