D-Link xStack DGS-3120 Series - Page 1061

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
1056
Format
config trusted_host [<ipaddr> | <ipv6addr> | network <network_address> | ipv6_prefix
<ipv6networkaddr>] [add | delete] {snmp | telnet | ssh | http | https | ping | all}
Parameters
<ipaddr> - The IP address of the trusted host.
<ipv6addr> - The IPv6 address of the trusted host.
network - The network address of the trusted network. The form of network address is
xxx.xxx.xxx.xxx/y.
<network_address> - Enter the network address used here.
ipv6_prefix - The IPv6 subnet prefix of the trusted network.
<ipv6networkaddr> - Enter the IPv6 subnet prefix here.
add - Add interfaces for that trusted host.
delete - Delete interfaces for that trusted host.
snmp - (Optional) Specify trusted host for SNMP.
telnet - (Optional) Specify trusted host for TELNET.
ssh - (Optional) Specify trusted host for SSH.
http - (Optional) Specify trusted host for HTTP.
https - (Optional) Specify trusted host for HTTPs.
ping - (Optional) Specify trusted host for PING.
all - (Optional) Specify trusted host for all application.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To configure the trusted host:
DGS-3120-24TC:admin# config trusted_host 10.48.74.121 add ssh telnet
Command: config trusted_host 10.48.74.121 add ssh telnet
Success.
DGS-3120-24TC:admin#
114-4 show trusted_host
Description
This command is used to display a list of trusted hosts entered on the Switch using the create
trusted_host command above.
Format
show trusted_host
Parameters
None.