D-Link xStack DGS-3120 Series - Page 1088

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
1083
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To set the priority of the voice VLAN to be six:
DGS-3120-24TC:admin# config voice_vlan priority 6
Command: config voice_vlan priority 6
Success.
DGS-3120-24TC:admin#
119-4 config voice_vlan oui
Description
This command is used to configure the user-defined voice traffic’s OUI. The OUI is used to identify
the voice traffic. There are a number of pre-defined OUIs. The user can further define the user-
defined OUIs if needed.The user-defined OUI cannot be the same as the pre-defined OUI.
The following are the pre-defined voice traffic’s OUI:
OUI Vendor Mnemonic name
00:E0:BB 3COM 3com
00:03:6B Cisco cisco
00:E0:75 Veritel veritel
00:D0:1E Pingtel pingtel
00:01:E3 Siemens siemens
00:60:B9 NEC/ Philips nec&philips
00:0F:E2 Huawei-3COM huawei&3com
00:09:6E Avaya avaya
Format
config voice_vlan oui [add | delete] <macaddr> <macmask> {description <desc 32>}
Parameters
oui - Specify the OUI used for this configuration.
add - Adding a user-defined OUI of a voice device vendor.
delete - Deleting a user-defined OUI of a voice device vendor.
<macaddr> - The user-defined OUI MAC address.
<macmask> - The user-defined OUI MAC address mask.
description - (Optional) The description for the user-defined OUI.
<desc 32> - Enter the description here. This value can be up to 32 characters long.