D-Link xStack DGS-3120 Series User Manual

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
1089
DGS-3120-24TC:admin#show voice_vlan ports 1:1-1:5
Command: show voice_vlan ports 1:1-1:5
Ports Status Mode
----- --------- --------------
1:1 Disabled Auto Untagged
1:2 Disabled Auto Untagged
1:3 Disabled Auto Untagged
1:4 Enabled Auto Untagged
1:5 Enabled Auto Untagged
DGS-3120-24TC:admin#
119-11 show voice_vlan voice device
Description
This command is used to show voice devices that are connected to the ports. The start time is the
time when the device is detected on this port and the activate time is the latest time the device
sent traffic.
Format
show voice_vlan voice_device {ports <portlist>}
Parameters
ports - (Optional) Specify the list of ports to be configured here.
<portlist> - Enter a list of ports used to be displayed here.
Restrictions
None.
Example
To display the voice devices that are connected to the ports 1:1-1:5:

D-Link xStack DGS-3120 Series Specifications

General

MAC Address Table	16K entries
Ports	10/100/1000BASE-T ports
VLANs	4094
Jumbo Frame	Up to 9KB
Power Supply	Internal power supply (depending on model)
Power over Ethernet (PoE)	No
Layer 3 Features	RIP
Quality of Service (QoS)	8 queues per port, DiffServ
Security Features	ACLs
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
SFP Ports	Combo 10/100/1000BASE-T/SFP ports and/or dedicated SFP/SFP+ ports (depending on model)