D-Link xStack DGS-3120 Series User Manual

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
1095
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure WAC auth method:
DGS-3120-24TC:admin# config wac method radius
Command: config wac method radius
Success.
DGS-3120-24TC:admin#
120-5 config wac default_redirpath
Description
This command is used to configure WAC default redirect path. If default redirect path is configured,
the user will be redirected to the default redirect path after successful authentication.
When the string is cleared, the client will not be redirected to another URL after successful
authentication.
Format
config wac default_redirpath <string 128>
Parameters
<string 128> - The URL that the client will be redirected to after successful authentication. By
default, the redirected path is cleared. This value can be up to 128 characters long.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To config WAC default redirect URL:
DGS-3120-24TC:admin# config wac default_redirpath http://www.dlink.com
Command: config wac default_redirpath http://www.dlink.com
Success.
DGS-3120-24TC:admin#

D-Link xStack DGS-3120 Series Specifications

General

MAC Address Table	16K entries
Ports	10/100/1000BASE-T ports
VLANs	4094
Jumbo Frame	Up to 9KB
Power Supply	Internal power supply (depending on model)
Power over Ethernet (PoE)	No
Layer 3 Features	RIP
Quality of Service (QoS)	8 queues per port, DiffServ
Security Features	ACLs
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
SFP Ports	Combo 10/100/1000BASE-T/SFP ports and/or dedicated SFP/SFP+ ports (depending on model)