D-Link xStack DGS-3120 Series User Manual

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
1096
120-6 config wac clear_default_redirpath
Description
This command is used to clear the WAC default redirect path. When the string is cleared, the client
will not be redirected to another URL after successful authentication.
Format
config wac clear_default_redirpath
Parameters
None.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To clear WAC default redirect URL:
DGS-3120-24TC:admin#config wac clear_default_redirpath
Command: config wac clear_default_redirpath
Success.
DGS-3120-24TC:admin#
120-7 config wac virtual_ip
Description
This command is used to configure the virtual IP address for WAC. The virtual IP of WAC is used
to accept authentication request from unauthenticated host. Only requests sent to this IP will get
response correctly.
This IP does not respond to ARP request or ICMP packet!
Format
config wac virtual_ip {<ipaddr> | <ipv6addr>}(1)
Parameters
<ipaddr> - Specify the IP address of the virtual IP.
<ipv6addr> - Specify the IPv6 address of the virtual IP.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.

D-Link xStack DGS-3120 Series Specifications

General

MAC Address Table	16K entries
Ports	10/100/1000BASE-T ports
VLANs	4094
Jumbo Frame	Up to 9KB
Power Supply	Internal power supply (depending on model)
Power over Ethernet (PoE)	No
Layer 3 Features	RIP
Quality of Service (QoS)	8 queues per port, DiffServ
Security Features	ACLs
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
SFP Ports	Combo 10/100/1000BASE-T/SFP ports and/or dedicated SFP/SFP+ ports (depending on model)