D-Link xStack DGS-3120 Series User Manual

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
1131
virtual MAC into switch L3
table. The port where the
MAC is learned from is
invalid.
addr> MAC <vrrp-mac-addr> into
L3 table. Port <mac-port> is
invalid
Failed when adding a
virtual MAC into switch L3
table. The interface where
the MAC is learned from is
invalid.
Failed to add virtual IP <vrrp-ip-
addr> MAC <vrrp-mac-addr> into
L3 table. Interface <mac-intf> is
invalid
Error
Failed when adding a
virtual MAC into switch L3
table. The box where the
MAC is learned from is
invalid.
Failed to add virtual IP <vrrp-ip-
addr> MAC <vrrp-mac-addr> into
L3 table. Box id <mac-box> is
invalid
Error
Failed when adding a
virtual MAC into switch
chip’s L3 table.
Failed to add virtual IP <vrrp-ip-
addr> MAC <vrrp-mac-addr> into
chip L3 table. Errcode <vrrp-
errcode>
Error
Failed when deleting a
virtual MAC from switch
chip’s L3 table.
Failed to delete virtual IP <vrrp-
ip-addr> MAC <vrrp-mac-addr>
from chip L3 table. Errcode
<vrrp-errcode>
Error
RIPng
The RIPng state of
interface changed
RIPng protocol on interface <intf-
name> changed state to
<enabled | disabled>
Informational

D-Link xStack DGS-3120 Series Specifications

General

MAC Address Table	16K entries
Ports	10/100/1000BASE-T ports
VLANs	4094
Jumbo Frame	Up to 9KB
Power Supply	Internal power supply (depending on model)
Power over Ethernet (PoE)	No
Layer 3 Features	RIP
Quality of Service (QoS)	8 queues per port, DiffServ
Security Features	ACLs
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
SFP Ports	Combo 10/100/1000BASE-T/SFP ports and/or dedicated SFP/SFP+ ports (depending on model)