D-Link xStack DGS-3120 Series User Manual

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
1134
restarts after the interval time.
Binding
1. swLoopDetectPortIndex
2. swVlanLoopDetectVID
swBpduProtectionUnderAttackingTrap
When the BPDU Protection trap is enabled, if
the specific port changes from a normal state
to an under attack state, a trap will be sent
out.
Binding
1. swBpduProtectionPortIndex
2. swBpduProtectionPortMode
1.3.6.1.4.1.171.12.76.4.0.1
swBpduProtectionRecoveryTrap
When the BPDU Protection trap is enabled, if
the specific port changes from an under
attack state to a normal state, a trap will be
sent out.
1. swBpduProtectionPortIndex
2. swBpduProtectionRecoveryMethod
1.3.6.1.4.1.171.12.76.4.0.2
swERPSSFDetectedTrap
When a signal failure occurs, a trap will be
generated.
Binding
1. swERPSNodeId
1.3.6.1.4.1.171.12.78.4.0.1
swERPSSFClearedTrap
When the signal failure clears, a trap will be
generated.
Binding
1. swERPSNodeId
1.3.6.1.4.1.171.12.78.4.0.2
swERPSRPLOwnerConflictTrap When a conflict occurs, a trap will be
generated.
Binding
1. swERPSNodeId
1.3.6.1.4.1.171.12.78.4.0.3
dot1agCfmFaultAlarm
A MEP has a persistent defect condition. A
notification
(fault alarm) is sent to the management
entity with the OID
of the MEP that has detected the fault.
Binding
1. dot1agCfmMepHighestPrDefect
1.3.111.2.802.1.1.8.0.1
swCFMExtAISOccurred
A notification is generated when local MEP
enters AIS status.
Binding
1. dot1agCfmMdIndex
2. dot1agCfmMaIndex
3. dot1agCfmMepIdentifier
1.3.6.1.4.1.171.12.86.100.0.1
swCFMExtAISCleared
A notification is generated when local MEP
exits AIS status.
Binding
1. dot1agCfmMdIndex
2. dot1agCfmMaIndex
3. dot1agCfmMepIdentifier
1.3.6.1.4.1.171.12.86.100.0.2
swCFMExtLockOccurred
A notification is generated when local MEP
enters lock status.
Binding
1. dot1agCfmMdIndex
2. dot1agCfmMaIndex
3. dot1agCfmMepIdentifier
1.3.6.1.4.1.171.12.86.100.0.3
swCFMExtLockCleared
A notification is generated when local MEP
exits lock status.
Binding
1. dot1agCfmMdIndex
2. dot1agCfmMaIndex
3. dot1agCfmMepIdentifier
1.3.6.1.4.1.171.12.86.100.0.4
swFanFailure
Fan Failure notification.
Binding
1. swFanUnitIndex
2. swFanID
1.3.6.1.4.1.171.12.11.2.2.3.0.1
swFanRecover
Fan Recover notification.
Binding
1. swFanUnitIndex
1.3.6.1.4.1.171.12.11.2.2.3.0.2

D-Link xStack DGS-3120 Series Specifications

General

MAC Address Table	16K entries
Ports	10/100/1000BASE-T ports
VLANs	4094
Jumbo Frame	Up to 9KB
Power Supply	Internal power supply (depending on model)
Power over Ethernet (PoE)	No
Layer 3 Features	RIP
Quality of Service (QoS)	8 queues per port, DiffServ
Security Features	ACLs
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
SFP Ports	Combo 10/100/1000BASE-T/SFP ports and/or dedicated SFP/SFP+ ports (depending on model)