D-Link xStack DGS-3120 Series - Page 142

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
137
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure a “two rates three color” flow meter:
DGS-3120-24TC:admin#config egress_flow_meter profile_id 1 access_id 1 tr_tcm
cir 1000 cbs 200 pir 2000 pbs 200 exceed permit replace_dscp 21 violate drop
Command: config egress_flow_meter profile_id 1 access_id 1 tr_tcm cir 1000 cbs
200 pir 2000 pbs 200 exceed permit replace_dscp 21 violate drop
Success.
DGS-3120-24TC:admin#
7-7 show egress_flow_meter
Description
This command is used to display the egress flow-based metering configuration.
Format
show egress_flow_meter {[profile_id <value 1-4> | profile_name <name 1-32>] {access_id
<value 1-128>}}
Parameters
profile_id - (Optional) Specify the index of access list profile.
<value 1-4> - Enter the profile ID used here. This value must be between 1 and 4. A lower
value denotes a higher priority.
profile_name - (Optional) Specify the name of the profile.
<name 1-32> - Enter the profile name used here. This name can be up to 32 characters long.
access_id - (Optional) Specify the access ID.
<value 1-128> - Enter the access ID used here. This value must be between 1 and 128. A
lower value denotes a higher priority.
Restrictions
None.
Example
To display current egress flow meter table: