D-Link xStack DGS-3120 Series User Manual

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
139
DGS-3120-24TC:admin# create port_group id 2 name group2
Command: create port_group id 2 name group2
Success.
DGS-3120-24TC:admin#
7-9 config port_group
Description
This command is used to add or delete a port list to a port group.
Format
config port_group [id <value 1-64> | name <name 16 >] [add | delete] [<portlist> |all]
Parameters
id - Specify the port group ID.
<value 1-64> - Enter the port group ID used here. This value must be between 1 and 64.
name - Specify the port group name.
<name 16> - Enter the port group name here. This name can be up to 16 characters long.
add - Add a port list to this port group.
delete - Delete a port list from this port group.
<portlist> - Enter a list of ports used for the configuration here.
all - Specify that all the ports will be used for this configuration.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
Add port list “1-3” to the port group which ID is “2”:
DGS-3120-24TC:admin# config port_group id 2 add 1:1-1:3
Command: config port_group id 2 add 1:1-1:3
Success.
DGS-3120-24TC:admin#
7-10 delete port_group
Description
This command is used to delete port group.
Format
delete port_group [id <value 1-64> | name <name 16>]

D-Link xStack DGS-3120 Series Specifications

General

MAC Address Table	16K entries
Ports	10/100/1000BASE-T ports
VLANs	4094
Jumbo Frame	Up to 9KB
Power Supply	Internal power supply (depending on model)
Power over Ethernet (PoE)	No
Layer 3 Features	RIP
Quality of Service (QoS)	8 queues per port, DiffServ
Security Features	ACLs
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
SFP Ports	Combo 10/100/1000BASE-T/SFP ports and/or dedicated SFP/SFP+ ports (depending on model)