D-Link xStack DGS-3120 Series - Page 145

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
140
Parameters
id - Specify the port group ID.
<value 1-64> - Enter the port group ID used here. This value must be between 1 and 64.
name - Specify the port group name.
<name 16> - Enter the port group name here. This name can be up to 16 characters long.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To delete the port group which ID is “2”:
DGS-3120-24TC:admin# delete port_group id 2
Command: delete port_group id 2
Success.
DGS-3120-24TC:admin#
7-11 show port_group
Description
This command is used to display the port group information.
Format
show port_group {id<value 1-64> | name<name 16>}
Parameters
id - (Optional) Specify the port group ID.
<value 1-64> - Enter the port group ID used here. This value must be between 1 and 64.
name - (Optional) Specify the port group name.
<name 16> - Enter the port group name here. This name can be up to 16 characters long.
If not specified parameter, will show all the port group.
Restrictions
Only Administrator and Operator-level users can issue this command.
Example
To show all the port group information: