D-Link xStack DGS-3120 Series - Page 174

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
169
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To disable the IP interface for IPv6 link local automatic:
DGS-3120-24TC:admin#disable ipif_ipv6_link_local_auto newone
Command: disable ipif_ipv6_link_local_auto newone
Success.
DGS-3120-24TC:admin#
12-21 show ipif_ipv6_link_local_auto
Description
This command is used to display the link local address automatic configuration state.
Format
show ipif_ipv6_link_local_auto {<ipif_name 12>}
Parameters
<ipif_name 12> - (Optional) Enter the Ip interface name used here. This name can be up to 12
characters long.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
T o display the link local address automatic configuration state.
DGS-3120-24TC:admin#show ipif_ipv6_link_local_auto
Command: show ipif_ipv6_link_local_auto
IPIF: System Automatic Link Local Address: Disabled
DGS-3120-24TC:admin#
12-22 config ipif ipv6_autoconfig
Description
This command is used to enable or disable automatic configuration of the IPv6 address using
stateless auto-configuration.
This command is only available for the VLAN IPv6 interface (IPv6 is enabled on the VLAN
interface). By default the auto-configuration option is disabled.