D-Link xStack DGS-3120 Series User Manual

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
170
When enabling this configuration, the interface enables IPv6 processing and a router
advertisement containing an assigned global address prefix will be received on this interface from
an IPv6 router. The resulting address that is a combination of the prefix and the interface identifier
will be assigned to the interface.
When disabling this configuration, the obtained global unicast address will be removed from the
interface.
If the default option is specified, it will accord the received router advertisement to insert a default
route to the IPv6 routing table. The type of this default route is SLAAC. It has a higher route
preference than the dynamic default route which learnt from RIPng, OSPFv3, or BGP+. The static
default route has higher route preference than it.
Format
config ipif ipv6_autoconfig <ipif_name 12> state [enable | disable] {default}
Parameters
<ipif_name 12> - Enter the IP interface's name that will be configured here. This name can be up
12 characters long.
state - Specify the IPv6 automatic configuration's state.
enable - Specify to enable IPv6 automatic configuration.
disable - Specify to disable IPv6 automatic configuration.
default - (Optional) Specify that if a default router is selected on this interface, the default
keyword causes a default route to be installed using that default router. The default keyword
can be specified on only one interface.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
This example shows how to configure the state of the automatic configuration of the IPv6 address
for the System IP interface.
DGS-3120-24TC:admin# config ipif ipv6_autoconfig System state enable
Command: config ipif ipv6_autoconfig System state enable
Success.
DGS-3120-24TC:admin#

D-Link xStack DGS-3120 Series Specifications

General

MAC Address Table	16K entries
Ports	10/100/1000BASE-T ports
VLANs	4094
Jumbo Frame	Up to 9KB
Power Supply	Internal power supply (depending on model)
Power over Ethernet (PoE)	No
Layer 3 Features	RIP
Quality of Service (QoS)	8 queues per port, DiffServ
Security Features	ACLs
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
SFP Ports	Combo 10/100/1000BASE-T/SFP ports and/or dedicated SFP/SFP+ ports (depending on model)