D-Link xStack DGS-3120 Series - Page 231

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
226
Format
clear cfm pkt_cnt {[ports <portlist> {[rx | tx]} | [rx | tx] | ccm]}
Parameters
ports - (Optional) The ports which require need the counters clearing. If not specified, all ports
will be cleared.
<portlist> - Enter the list of ports used for this configuration here.
rx - (Optional) Specify to clear the RX counter.
tx - (Optional) Specify to clear the TX counter. If not specified, both of them will be cleared.
rx - (Optional) Specify to clear the RX counter.
tx - (Optional) Specify to clear the TX counter. If not specified, both of them will be cleared.
ccm - (Optional) Specify the CCM RX counters.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To clear the CFM packet’s RX/TX counters:
DGS-3120-24TC:admin# clear cfm pkt_cnt
Command: clear cfm pkt_cnt
Success.
DGS-3120-24TC: clear cfm pkt_cnt ccm
Command: clear cfm pkt_cnt ccm
Success.
DGS-3120-24TC:admin#
19-27 config cfm trap
Description
This command is used to configure the state of the CFM trap.
Format
config cfm trap [ais | lock] state [enable | disable]
Parameters
ais - Specify the AIS trap status to be configured. If the trap status of AIS is enabled, a trap will
be sent out when an ETH-AIS event occurs or clears.
lock - Specify the LCK trap status that to be configured. If the trap status of LCK is enabled, a
trap will be sent out wnen an ETH-LCK event occurs or clears.
state – Specify the state of the CFM trap.