D-Link xStack DGS-3120 Series - Page 249

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
244
debug vrrp clear counter (RI Mode Only)
debug vrrp log state [enable | disable] (RI Mode Only)
debug vrrp show counter (RI Mode Only)
debug vrrp show flag (RI Mode Only)
debug vrrp show log state (RI Mode Only)
debug vrrp state [enable | disable] (RI Mode Only)
debug pim ssm (RI Mode Only)
no debug pim ssm (RI Mode Only)
debug show cpu utilization
22-1 debug error_log
Description
This command is used to dump, clear or upload the software error log to a TFTP server.
Format
debug error_log [dump | clear | upload_toTFTP <ipaddr> <path_filename 64>]
Parameters
dump - Display the debug message of the debug log.
clear - Clear the debug log.
upload_toTFTP - Upload the debug log to a TFTP server specified by IP address.
<ipaddr> - Specify the IPv4 address of the TFTP server.
<path_filename 64> - The pathname specifies the DOS pathname on the TFTP server. It can
be a relative pathname or an absolute pathname. This value can be up to 64 characters
long.
Restrictions
Only Administrator-level users can issue this command.
Example
To dump the error log: