D-Link xStack DGS-3120 Series User Manual

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
251
Example
To show debug cpu port counter by CoS on port 1:1 and 1:2:
DGS-3120-24TC:admin#debug show cpu port counter 1:1-1:2 by_cos
Command: debug show cpu port counter 1:1-1:2 by_cos
Ports:1
CoS 0 rx:0 tx:0
1 rx:0 tx:0
2 rx:0 tx:0
3 rx:0 tx:0
4 rx:0 tx:0
5 rx:0 tx:0
6 rx:0 tx:0
7 rx:0 tx:0
unknown rx:0 tx:0
total rx:0 tx:0
Ports:2
CoS 0 rx:0 tx:0
1 rx:0 tx:0
2 rx:0 tx:0
3 rx:0 tx:0
4 rx:0 tx:0
5 rx:0 tx:0
6 rx:0 tx:0
7 rx:0 tx:0
unknown rx:0 tx:0
total rx:0 tx:0
DGS-3120-24TC:admin#
22-9 debug show jwac auth_info
Description
This command is used to show debug information of JWAC.
Format
debug show jwac auth_info
Parameters
None.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.

D-Link xStack DGS-3120 Series Specifications

General

MAC Address Table	16K entries
Ports	10/100/1000BASE-T ports
VLANs	4094
Jumbo Frame	Up to 9KB
Power Supply	Internal power supply (depending on model)
Power over Ethernet (PoE)	No
Layer 3 Features	RIP
Quality of Service (QoS)	8 queues per port, DiffServ
Security Features	ACLs
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
SFP Ports	Combo 10/100/1000BASE-T/SFP ports and/or dedicated SFP/SFP+ ports (depending on model)