D-Link xStack DGS-3120 Series - Page 269

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
264
state - Specify to set the configured OSPF debug flag’s state.
enable - Specify that the configured OSPF debug flag’s state will be enabled.
disable - Specify that the configured OSPF debug flag’s state will be disabled.
Restrictions
Only Administrator-level users can issue this command.
Example
To enable OSPF neighbor state change debug:
DGS-3120-24TC:admin#debug ospf neighbor_state_change state enable
Command: debug ospf neighbor_state_change state enable
Success.
DGS-3120-24TC:admin#
To enable OSPF interface state change debug:
DGS-3120-24TC:admin#debug ospf interface_state_change state enable
Command: debug ospf interface_state_change state enable
Success.
DGS-3120-24TC:admin#
To enable all OSPF LSA debug flags:
DGS-3120-24TC:admin#debug ospf lsa all state enable
Command: debug ospf lsa all state enable
Success.
DGS-3120-24TC:admin#
To enable all OSPF packet debug flags:
DGS-3120-24TC:admin#debug ospf packet all state enable
Command: debug ospf packet all state enable
Success.
DGS-3120-24TC:admin#
To enable the OSPF retransmission debug flag: