D-Link xStack DGS-3120 Series - Page 268

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
263
DGS-3120-24TC:admin#debug show address_binding binding_state_table
dhcpv6_snooping
Command: debug show address_binding binding_state_table dhcpv6_snooping
S (State) - S: Start, L: Live, D :Detection, R: Renew, B: Bound
Time - Expiry Time (sec)
IP Address MAC Address S Time Port
--------------------------------------- ----------------- -- ---------- -----
2001:2222:1111:7777:5555:6666:7777:8888 00-00-00-00-00-02 S 50 5
2001::1 00-00-00-00-03-02 B 100 6
Total entries : 2
DGS-3120-24TC:admin#
22-27 debug ospf (RI Mode Only)
Description
This command is used to enable or disable OSPF debug flags.
Format
debug ospf [neighbor_state_change | interface_state_change {dr_bdr_selection} | lsa {all |
originating | installing | receiving | flooding} (1) | packet {all | receiving | sending} (1) |
retransmission | spf {all | intra | inter | extern} (1) | timer | virtual_link | route | redistribution]
state [enable | disable]
Parameters
neighbor_state_change - The state of the OSPF neighbor state change debug.
interface_state_change - The state of the OSPF interface state change debug.
dr_bdr_selection - (Optional) Specify to include or exclude debug information for DR/BDR
selection.
lsa - Specify the state of the designated debug flag.
all - Specify to set all LSA debug flags.
originating - Specify to set LSA originating debug flag.
installing - Specify to set LSA installing debug flag.
receiving - Specify to set LSA receiving debug flag.
flooding - Specify to set LSA flooding debug flag.
packet - Specify the state of the designated debug flag.
all - Specify to set all packet debug flags.
receiving - Specify to set packet receiving debug flag.
sending - Specify to set packet sending debug flag.
retransmission - Specify the state of the OSPF retransmission debug flag.
spf - Specify the state of the designated debug flag.
all - Specify to set all SPF debug flags.
intra - Specify to set intra-area SPF debug flag.
inter - Specify to set inter-area SPF debug flag.
extern - Specify to set AS external SPF debug flag.
timer - Specify the state of the OSPF timer debug flag.
virtual_link - Specify the state of the OSPF virtual link debug flag.
route - Specify the state of OSPF route debug flag.
redistribution - Specify the state of the OSPF redistribution debug flag.