D-Link xStack DGS-3120 Series - Page 267

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
262
Restrictions
Only Administrator-level users can issue this command.
Example
To stop IMPB debug: starting when the IMPB module receives an ARP/IP or DHCP packet:
DGS-3120-24TC:admin# no debug address_binding
Command: no debug address_binding
Success.
DGS-3120-24TC:admin#
22-26 debug show address_binding binding_state_table (RI and EI
Mode Only)
Description
This command is used to display the ND snooping and DHCPv6 binding state table.
Format
debug show address_binding binding_state_table [nd_snooping | dhcpv6_snooping]
Parameters
nd_snooping – Display the ND Snooping binding state table.
dhcpv6_snooping – Display the DHCPv6 binding state table.
Restrictions
Only Administrator-level users can issue this command.
Example
To display the DHCPv6 snooping binding state of entries in BST: