D-Link xStack DGS-3120 Series - Page 266

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
261
22-24 debug ripng flag (RI Mode Only)
Description
This command is used to enable or disable the RIPng debug flag.
Format
debug ripng flag [{interface | packet [all | rx | tx ] | route} | all] state [enable | disable]
Parameters
interface - (Optional) The state of the RIPng interface debug. The default setting is disabled.
packet - (Optional) Specify the type of packets with debug flags.
all - Set all packets with debug flags.
rx - Set inbound packets with debug flag.
tx - Set outbound packets with debug flag.
route - (Optional) The state of the RIPng route debug. The default setting is disabled.
all - Specify to configure all debug flags.
state - Specify the designated flag status.
enable - Enable the designated flags
disable - Disable designated flags.
Restrictions
Only Administrator-level users can issue this command.
Example
To enable the ripng interface debug:
DGS-3120-24TC:admin#debug ripng flag interface state enable
Command: debug ripng flag interface state enable
Success.
DGS-3120-24TC:admin#
22-25 no debug address_binding (RI and EI Mode Only)
Description
This command is used to stop the IMPB debug starting when the IMPB module receives an
ARP/IP packet or a DHCP packet.
Format
no debug address_binding
Parameters
None.