D-Link xStack DGS-3120 Series - Page 278

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
273
22-36 debug ospf show flag (RI Mode Only)
Description
This command is used to display the OSPF debug flag’s settings.
Format
debug ospf show flag
Parameters
None.
Restrictions
Only Administrator-level users can issue this command.
Example
To display the current OSPF debug flag’s settings:
DGS-3120-24TC:admin#debug ospf show flag
Command: debug ospf show flag
Global State: Disabled
Current OSPF Flags Setting:
Neighbor State Change
Interface State Change
Lsa Originating
Lsa Operating
Lsa Receiving
Lsa Flooding
Packet Receiving
Packet Sending
Retransmission
SPF Intra
SPF Inter
SPF Extern
DGS-3120-24TC:admin#
22-37 debug ospf show log state (RI Mode Only)
Description
This command is used to display the OSPF debug log state.