D-Link xStack DGS-3120 Series - Page 282

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
277
DGS-3120-24TC:admin#debug ospf show summary_list
Command: debug ospf show summary_list
OSPF Summary List:
Area 0.0.0.0:
Circuit: 1.1.1.1
Neighbor: 90.2.0.1 IP: 1.1.1.2
LSID: 1.1.1.1 RTID: 1.1.1.1
Circuit: 2.2.2.1
Circuit: 10.1.1.6
DGS-3120-24TC:admin#
22-41 debug ospf state (RI Mode Only)
Description
This command is used to set the OSPF debug global state.
Format
debug ospf state [enable | disable]
Parameters
enable - Specify that the OSPF debug global state will be enabled.
disable - Specify that the OSPF debug global state will be disabled.
Restrictions
Only Administrator-level users can issue this command.
Example
To enable the OSPF debug global state:
DGS-3120-24TC:admin#debug ospf state enable
Command: debug ospf state enable
Success.
DGS-3120-24TC:admin#
22-42 debug vrrp (RI Mode Only)
Description
This command is used to set VRRP debug flags.