D-Link xStack DGS-3120 Series - Page 344

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
339
27-2 show filter dhcp_server
Description
This command is used to display the DHCP server/client filter list created on the Switch.
Format
show filter dhcp_server
Parameters
None.
Restrictions
None.
Example
To display the DHCP server/client filter list created on the Switch:
DGS-3120-24TC:admin#show filter dhcp_server
Command: show filter dhcp_server
Enabled Ports: 1:1-1:10
Trap State: Disabled
Log State: Disabled
Illegal Server Log Suppress Duration:5 minutes
Permit DHCP Server/Client Table:
Server IP Address Client MAC Address Port
----------------- ------------------ --------------------
10.1.1.1 00-00-00-00-00-01 1:1-1:24
Total Entries: 1
DGS-3120-24TC:admin#
27-3 config filter dhcp_server log
Description
This command is used to enable or disable the log function.
Format
config filter dhcp_server log [enable | disable]