D-Link xStack DGS-3120 Series - Page 346

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
341
27-5 create filter dhcpv6_server permit sip
Description
This command used to create a permit entry. The specific DHCPv6 server packets, with the source
IPv6 address, will be forwarded on the specified port(s).
Format
create filter dhcpv6_server permit sip <ipv6addr> ports [<portlist> | all]
Parameters
<ipv6addr> - Specify the source address of the entry which will be created into the Filter
DHCPv6 server forward list.
ports - Specify the list of ports used for this configuration.
<portlist> - Enter the list of ports, used for this configuration, here.
all - Specify that all ports will be used for this configuration.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To create a Filter DHCPv6 server permit entry on port 1:5:
DGS-3120-24TC:admin#create filter dhcpv6_server permit sip 2200::5 ports 1:5
Command: create filter dhcpv6_server permit sip 2200::5 ports 1:5
Success.
DGS-3120-24TC:admin#
27-6 config filter dhcpv6_server log
Description
This command is used to enable or disable the Filter DHCPv6 server log state.
Format
config filter dhcpv6_server log [enable | disable]
Parameters
enable - Specify that the log for the Filter DHCPv6 server will be enabled. The log for Filter
DHCPv6 server will be generated.
disable - Specify that the log for the Filter DHCPv6 server will be disabled.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.