D-Link xStack DGS-3120 Series - Page 359

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
354
enable - Specify to enable the check function.
disable - Specify to disable the check function.
interface_id - (Optional) Specify the format of the Interface ID.
default - Specify to used the default formation for the Interface ID.
cid - Specify to use the CID format for the Interface ID.
vendor1 - Specify to use the Vendor 1 format for the Interface ID.
Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
Example
To configure the DHCPv6 relay Option 18:
DGS-3120-24TC:admin#config dhcpv6_relay option_18 state enable
Command: config dhcpv6_relay option_18 state enable
Success.
DGS-3120-24TC:admin# config dhcpv6_relay option_18 check enable
Command: config dhcpv6_relay option_18 check enable
Success.
DGS-3120-24TC:admin# config dhcpv6_relay option_18 interface_id default
Command: config dhcpv6_relay option_18 interface_id default
Success.
DGS-3120-24TC:admin# config dhcpv6_relay option_18 interface_id cid
Command: config dhcpv6_relay option_18 interface_id cid
Success.
DGS-3120-24TC:admin# config dhcpv6_relay option_18 interface_id vendor1
Command: config dhcpv6_relay option_18 interface_id vendor1
Success.
DGS-3120-24TC:admin#
28-8 show dhcpv6_relay
Description
This command is used to display the current DHCPv6 relay configuration of the specified or all IP
Interfaces.
Format
show dhcpv6_relay {ipif <ipif_name 12>}