D-Link xStack DGS-3120 Series - Page 360

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
355
Parameters
ipif - (Optional) The IP information for DHCPv6 relay.
<ipif_name 12> - The name of the IP interface in which DHCPv6 relay is to be enabled.
Restrictions
None.
Example
To show the DHCPv6 relay configuration of all interfaces:
DGS-3120-24TC:admin#show dhcpv6_relay
Command: show dhcpv6_relay
DHCPv6 Relay Global State : Disabled
DHCPv6 Hops Count Limit : 4
DHCPv6 Relay Information Option 18 State : Enabled
DHCPv6 Relay Information Option 18 Check : Disabled
DHCPv6 Relay Information Option 18 Interface ID Type : Default
DHCPv6 Relay Information Option 37 State : Disabled
DHCPv6 Relay Information Option 37 Check : Disabled
DHCPv6 Relay Information Option 37 Remote ID Type : Default
DHCPv6 Relay Information Option 37 Remote ID :
---------------------------------------------------------------
IP Interface : System
DHCPv6 Relay Status : Enabled
Server Address : 2001:DB8:1234::218:FEFF:FEFB:CC0E
Total Entries : 1
DGS-3120-24TC:admin#
28-9 config dhcpv6_local_relay vlan
Description
This command is used to enable or disable the DHCPv6 local relay function for a specified VLAN.
Format
config dhcpv6_local_relay vlan [<vlan_name 32> | vlanid <vlan_id>] state [enable | disable]
Parameters
vlan - Specify the VLAN name that will be used for this configuration.
<vlan_name 32> - Enter the VLAN name that will be used for this configuration.
vlanid - Specify the VLAN ID that will be used for this configuration.
<vlan_id> - Enter the VLAN ID that will be used for this configuration.
state - Specify the DHCPv6 local relay function's state for the specified VLAN.
enable - Specify to enable the DHCPv6 local relay function's state for the specified VLAN.
disable - Specify to disable the DHCPv6 local relay function's state for the specified VLAN.