D-Link xStack DGS-3120 Series User Manual

xStack
®
DGS-3120 Series Layer 3 Managed Gigabit Ethernet Switch CLI Reference Guide
378
Total Static Entries: 4
Dynamic Host Name Table
Total Dynamic Entries: 0
DGS-3120-24TC:admin#
31-8 enable dns_resolver
Description
This command is used to enable the DNS Resolver state of the Switch.
Format
enable dns_resolver
Parameters
None.
Restrictions
Only Administrators, Operators and Power-Users can issue this command.
Example
To configure the DNS Resolver state to enabled:
DGS-3120-24TC:admin# enable dns_resolver
Command: enable dns_resolver
Success.
DGS-3120-24TC:admin#
31-9 disable dns_resolver
Description
This command is used to disable the DNS Resolver state of the Switch.
Format
disable dns_resolver
Parameters
None.

D-Link xStack DGS-3120 Series Specifications

General

MAC Address Table	16K entries
Ports	10/100/1000BASE-T ports
VLANs	4094
Jumbo Frame	Up to 9KB
Power Supply	Internal power supply (depending on model)
Power over Ethernet (PoE)	No
Layer 3 Features	RIP
Quality of Service (QoS)	8 queues per port, DiffServ
Security Features	ACLs
Management	Web-based, CLI, SNMP
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
SFP Ports	Combo 10/100/1000BASE-T/SFP ports and/or dedicated SFP/SFP+ ports (depending on model)